Skip to main content

Challenge

Previously in this Lab, you have created variables and used them with operator blocks to move the arm mounted on the V5 Workcell to draw a square. In this challenge, you will use variables and operator blocks in a VEXcode V5 project to draw an additional square on the whiteboard.

workcell with two squares drawn on the whiteboard

Follow these steps to complete the challenge:

  • Open the 'Variables' project from the Play section.¬†
    • If needed, follow the steps in Play to recreate this project.
  • Add additional [Linear move] and operator blocks to draw the second square on the Workcell whiteboard as shown in the image above.
  • Run the project and sketch the final drawing in your engineering notebook.